Best I could find is this:
3Com EtherLink XL (3C900, 3C900-COMBO, 3C900B-COMBO, 3C900B-TPC,
3C900B-TPO), Fast EtherLink XL (3C905-TX, 3C905-T4, 3C905B-TX, 3C905B-T4)
Solaris Device Driver:
elxl
Device Type:
Network (Ethernet)
Adapters:
3Com EtherLink XL (3C900, 3C900-COMBO, 3C900B-COMBO, 3C900B-TPC,
3C900B-TPO), Fast EtherLink XL (3C905-TX, 3C905-T4, 3C905B-TX, 3C905B-T4)
Bus Type:
PCI
Preconfiguration Information
Supported Settings
Media Type:
Auto Select
Known Problems and Limitations
3C905B cards in a Compaq ProLiant 6500 can fail to generate interrupts.
There is no known workaround for this problem. However, since some slots
appear to be more prone to the problem than others, moving the card to
another PCI slot might help. Also, successive reboots of the machine have
succeeded in getting the card out of the wedged state.
>i am configuraing a x86 Solaris 7, but the network adaptor cannot
>recognised by the Configuration Assitance at boottime. I checked the
>sun site and it told me the card is supported but require additional
>configuration. my network adapter card is "3Com Ehterlink XL 3C905C".
>But I browse both the sun site and 3Com site there are no way to get
>the Unix driver for the card and also the installation stpes. Do you
>know what is meaned by the Additional Configuration? Since i went to
>the Additional Configuration page, the steps for me seems not
>useful.... it always asked me to go boot the machine using the
>Configuration Assist disk.... Pls can you give me any instruction on it?
>Thank You
>Sent via Deja.com http://www.deja.com/
>Before you buy.
by