Very Computer

first of all, check the io, irq of your card : cat /proc/pci if it's a PCI card
(must be I guess)
Write down the io, irq

( cat /proc/interrups if it's a ISA. )

If your card is a Ne2000 compatible, add the io, iqc into your rc.modules.

reboot, then see what will append !

io = input, output address
irq = interuptions

btw, I'm using too a modemcable and 10mbps are more efficient !

later

As for your card, there is a driver for almost every piece of hardware in
existence (even those old, stale ISA cards from long ago) on this site
... hmm, which is listed on my NETSCAPE (on my Win98 partition, of which
I haven't gotten a driver to mount it yet ...) bookmark file. Sorry.

: I've got a FastEthernet Pci PnP 32 bit card.It works ok with w95.
: I'm using it to access internet thru a cable modem.
: I installed redhat 5.0 but I cannot config the card.
: It's made in Taiwan by VIA Technologies and the model is SN5100TX.
: I was not able to find a single reference on the Internet about this company
: or about the model of the card.
: Would really appreciate any help.