Very Computer

eepro=0x210,3
eepro=0x210,03
eepro=0x210,3,0

For all of these I get an error saying it can' find my card. I've allso
tried the eexpress drive like this:
eexpress=0x210,3.

That, of course, also doesn't work.

Any suggestions or guesses?

alias eth0 = eepro
io=0x300 irq=5

good luck hope this helps -

Quote:> I'm installing RH 6.0 and I'm having trouble getting my Intell
EtherExpress
> Pro 10 detected. Autodetection hangs. I copied IRQ and I/O port
information
> from Windows, which detects it fine. However, the RH manual shows a
MEM
> parameter that I should also pass the module. I can't find anything
about a
> memory address associated with my network card under Windows, so I've
been
> leaving it blank. This is what I've tried passing the module:

> eepro=0x210,3
> eepro=0x210,03
> eepro=0x210,3,0

> For all of these I get an error saying it can' find my card. I've
allso
> tried the eexpress drive like this:
> eexpress=0x210,3.

> That, of course, also doesn't work.

> Any suggestions or guesses?

#modprobe eepro io=0x200 irq=10
        (device or resource busy)
#modprobe eepro io=0x300 irq=10
#rmmod eepro
#modprobe eepro
#modprobe eepro io=0x300
#/etc/rc.d/rc.inet1 start

It looks like I have to try first to put the card into wrong IO-port
then the right one, pull it out and put it in again without giving up
the IRQ- adress
It's a tricky thing to do but I put the whole procedure into
a script and it works now...

--
The idea that Bill Gates has appeared like a knight in shining armour
 to lead all customers out of a mire of technological chaos neatly
ignores the fact that it was he who, by peddling second-rate
technology, led them into it in the first place. (Douglas Adams)