Anyone know how to get the Sportster 128K to work? I have 2.0.36
compiled with the HiSax driver for the adapter, and at boot it
recognizes the device, but then I get the message:
Sportster: ISAC version (ff): 2085 V2.3
Sportster: HSCX version A: ??? B: ???
Sportster: wrong HSCX versions check IO address
Well, the device comes up on IRQ 7, with an IO address of 0x268. This
is odd because I have the jumpers set on the card for an IO address 320
(according to the USR book...). In my lilo.conf, I have the following
append="hisax=16,,7,0x320" I have the 2 commas because it was my
understanding that if not specified, the device protocol would use the
I am at a stone wall--Anybody know what I am doing wrong?