by > i have used the tulip driver that Linksys recomended from their
> website and i don't even get a link light on the hub...
> but they have an updated driver, but i don't know how to compile could
> someone please help me or
/usr/src/linux/drivers/net. Type 'cp tulip.c
/usr/src/linux/drivers/net' without the '' signs. Once you have copied
that file over you can recompile your kernel. In the /usr/src/linux
directory type in make menuconfig (it is a menu driven config menu,
under network device make sure the tulip driver is checked , it is
located under either EISA/VLB/PCI submenu (it make be different
depending on your current kernel version).
When you exit type in make dep ; make clean ; make boot (I believe that
is correct for RedHat, I haven't used it since last spring..I use all
slackware over here and I use make zlilo . After that is done type in
make modules ; make modules_install After that you can reboot. It
sounds like a lot of work but it is not bad once you do it once. The ;
stacks the commands sorta like a queue, it will do each command in the
order you type then in one at a time.
--
Dale Miracle "No matter where you go, there you are",
System Administrator Oliver's Law of Location
The Edge of Insanity "Real funny Scotty, now beam down my
"I've gone to look for my self, if I return before I get
back keep me here."