Hey:
Anyone had any successes with getting a 10/100 Macronix 98715 NIC to
work under linux? Essentially, my card doesn't detect the Ethernet
carrier.
I'm not sure if I have the correct drivers.
Thx
Keith
Anyone had any successes with getting a 10/100 Macronix 98715 NIC to
work under linux? Essentially, my card doesn't detect the Ethernet
carrier.
I'm not sure if I have the correct drivers.
Thx
Keith
It should use the tulip driver.Quote:> Hey:
> Anyone had any successes with getting a 10/100 Macronix 98715 NIC to
> work under linux? Essentially, my card doesn't detect the Ethernet
> carrier.
> I'm not sure if I have the correct drivers.
Quote:> Thx
> Keith
Hi,
I have a network card Cnet with a macronix chip 98715.
I use kernel 2.2.1 with tulip.c v0.89H
When i load tulip module the link led switch off on the card
when i diag the card with tulip_diag, here are the results :
Index #1: Found a Macronix 98725 PMAC adapter at 0xfc00.
Macronix 98725 PMAC Tulip chip registers at 0xfc00:
fe580000 ffffffff ffffffff 6a787fef 44697fff e4001000 00000000
e7fe0000
fffe0000 0fffcf08 fffcb6ff fffe0000 000020ce ffff0001 fffffff9
fff00000
03b00000 03b00000 03b00000 f80ffff0 00004200 00004200 00004200
00004200
00004200 00004200 00004200 00004200 00004200 00004200 00004200
00004200
Port selection is 10mpbs-serial, half-duplex.
Transmit stopped, Receive stopped, half-duplex.
The Rx process state is 'Stopped'.
The Tx process state is 'Stopped'.
The transmit threshold is 72.
Rx and TX are stopped.... why ?
i tried all module options.... nothing !
Should i change the net card ?
Thanks
Philippe Depouilly.
2. Is this system below compatible with RedHat (6.1)
3. CNET PRO120 aka Macronix 98715/tulip
5. Linksys- Macronix 98715...how to get these to work?
7. Macronix 98713 based NIC not working under Linux
9. Macronix NIC
10. Macronix MX987xx NIC-driver needed!!
11. 4Lan Ethernet NIC with Macronix Chipset
12. Macronix MX987xx NIC-driver needed!!