by I am running RedHat 7.0 on a two processor Intel PIII 800 MHz PC with the
following hardware.
500 Mbytes memory
CDROM
CDR
3 1/2 floppy
9 GB SCSI Drive
18 GB SCSI Drive
Oxygen GVX1 graphics card
I am having no success in configuring the X window system.
Running Xconfigurator the PCI Probe found a:
PCI Entry: 3Dlabs|Glint R3
X Server: Xf86_3DLAB
Xfree4 driver: glint
The Horizontal Sync was set to 30-69 KHz and the Vertical
Sync was set to 50-120 Hz as per the spec sheet.
Card memory was set to 32 Mb and the ClockChip setting
was set to no clockchip setting.
X was tested. On startup the screen flickered and failed with the message
problem with X configuration.
I am not sure how to proceed. Has anyone installed an Oxygen GVX1 graphics
card?
Anyone have any suggestions on how to proceed? Any help would be
appreciated.
Best regards,
Aaron