Board index Linux Setup

Boot disk dies after Slackware 3.0 setup

Boot disk dies after Slackware 3.0 setup

Post by Richard S. Lumpki » Thu, 15 Oct 1998 04:00:00




> After going through the entire setup process for Slackware 3.0, including
> creating the boot disk, I then reboot the machine and get the following
> message: "Loading... Uncompressing Linux...large kernel, low 1M tight...

> crc error

> --system halted"

How much physical memory do you have?
------------------------------------------------------------------------
Richard S. Lumpkin, Ph.D.                            Associate Professor
Department of Chemistry                                     256-890-6365
University of Alabama in Huntsville                     fax 256-890-6349
Huntsville, AL 35899                          http://chromophore.uah.edu
------------------------------------------------------------------------

 
 
 
Top

Boot disk dies after Slackware 3.0 setup

Post by Richard S. Lumpki » Thu, 15 Oct 1998 04:00:00



> > > After going through the entire setup process for Slackware 3.0, including
> > > creating the boot disk, I then reboot the machine and get the following
> > > message: "Loading... Uncompressing Linux...large kernel, low 1M tight...

> > > crc error

> > > --system halted"

> > How much physical memory do you have?

> 20 Megs

In that case it shouldn't be a memory shortage, I will defer to anyone
who might have a better idea.  Sorry not to be ablel to help.

------------------------------------------------------------------------
Richard S. Lumpkin, Ph.D.                            Associate Professor
Department of Chemistry                                     256-890-6365
University of Alabama in Huntsville                     fax 256-890-6349
Huntsville, AL 35899                          http://chromophore.uah.edu
------------------------------------------------------------------------


 
 
 
Top

1. Which boot disk goes with the Slackware 3.0 pcmcia.gz root disk?

I can't get the Slackware 3.0 pcmcia.gz root disk to work because the
cardmgr fails with the message: "Card Services release does not
match."  The kernel version on the bare and net boot disks provided
with Slackware 3.0 seem to have the same kernel version (1.2.13) as
the modules version for the pcmcia modules on the pcmcia.gz disk.
Which boot disk should I be using?

-Calvin

2. Can't create users if not root?

3. Slackware 3.0 installed boot disk dont see SCSI controller

4. Mandrake 6.0 install problems

5. Slackware 3.0 SCSI Boot Disk not seeing Adeptec 154x controller

6. Q: bus/cpu overclocking?

7. Slackware 3.0 'ascsi' boot disk is 1.3.18 (I want 1.2.13)

8. Mainframe vs Unix

9. Problems booting setup program for Slackware 3.0

10. Linux "BARE" boot disk (Slackware 3.0)

11. AHA2940 Slackware 3.0 boot disk

12. Newbie: Slackware: Setup: Configure Won't Work, How can I create a boot disk?

13. Child Died on setup with Slackware


All times are UTC
Board index