by sds_bea.. » Tue, 12 Sep 2000 23:22:49
I have setup an ISP and Used the modemtool to
install my modem. It says that it is trying to
connect but I never hear my modem dial and I
never get a connection. Are there some drivers
that I am missing? I am very new to Linux, so any
help would be appreciated.
Pat
Sent via Deja.com http://www.deja.com/
Before you buy.
1. modem trouble: USR 56K V.90 voice fax modem
Greetings,
Recently I purchased a U.S. Robotics 56 K voice/faxmodem and after a
week of labor it still doesn't work under linux. So far I have read the
serial-howto and the ppp-howto and neither have helped me in my pursuit.
Since linux doesn't like plug and play ...I manually jumpered the card
for IRQ 3 and COM 2. I then linked /dev/ttyS1 to /dev/modem but it
doesn't seem to help --linux still doesn't recognize my modem. So far I
have tried dialing out with seyon (I have yet to try minicom). Thank you
for your time and please reply at your convenience.
Regards,
Swamy
P.S. If possible please reply to both the group and me. Thanks again.
3. Of RH 6.2 newbies and the USR 56K Fax PCI modem
4. cable conn slow, slower, dead
5. help with PCI modem (Newcom 56K V.90 data/fax)
6. Xconfig settings for Compaq QVision
7. Which internal 56K voice/fax/data modem works with Linux?
9. GVC 56K v.90 fax modem with linux
10. Newbie - getting 433 Celeron with 56k ITU V.90 PCI Fax/Modem system for Linux
11. Can't get Boca internal 56K voice/data/fax modem to work