I've got a 2400 modem and i want to install it but with setserial i can't
get the com port lower then 9600.
How can i get the com port at 2400 ?
This is weird: under DOS, my modem (a 14,400 baud V.32bis V.42 PM14400FX)
works just fine, and will happily connect at 57,600 baud.
But when I try to connect to the same Annex number using DIP, the modem
will only negotiate a 2400 baud connection!
What might I be doing wrong? I specify "speed 57600" in DIP. Is there
something I need to do to configure my serial ports under Linux?