by Mike Lo » Fri, 27 Sep 1996 04:00:00
Last week I had posted an article regarding getting linux to recognize
the Pro/10 card. As it turned out, I had the Pro/10+ card. The same
driver (eepro.c) is used to deal with both cards, but you will need at
least version 0.10 of eepro.c to deal with the Pro/10+.
Hope this helps anyone out there with the same problem.
Mike Low
1. Install Intel EtherExpress Pro 10/10+ ISA card on Redhat 6.1 ---Please help
Hi,
I installed RedHat 6.1 on my PC(dual boot 98/Linux). Everything is fine
exception the RedHat can't recognize my ethernet card( Intel
EtherExpress ISA Pro 10/10+). The card works fine in 98.
During the installation, RedHat couldn't detect my card at all. So I
tried to load it manually. I tried two ways:
1. I put ether=5,0x210,0,0,eth0 ( the conf in my 98) in lilo.conf, then
reboot the machine. During the boot, lilo couldn't start eth0.
2. I run lsmod, I found nothing there. I do have
/lib/modules/2.2.12-20/net/eexpro.o file, so I said insmod eexpro. The
linux hangs forever. I have to power off the machine.
What did I do wrong? Please help!
Regards,
Michael
* Sent from RemarQ http://www.remarq.com The Internet's Discussion Network *
The fastest and easiest way to search and participate in Usenet - Free!
2. Spybox Consulting can solve your Unix Problems!
3. Intel Etherpress Pro 10/10+ driver......
5. Intel EtherExpress Pro/10+ with RedHat5.1 problem
6. Connot connect to port on server : networking problem?
10. Intel EtherExpress Pro 10/100
11. 3c509 & Intel EtherExpress Pro 10
12. Intel Etherexpress Pro/10+ ISA problem
13. Intel EtherExpress Pro/10+ v11.0 and 2.1.127