Redhat install questions

Redhat install questions

Post by Mark Man » Sat, 14 Sep 1996 04:00:00

I'm trying to install Redhat 3.0.3.  I'm having a problem with my scsi
controller.  My system. 2ide drives, 1cdrom(atapi).  1 adaptec 1540cf
with a fujitsu 1GB hardrive.  This hard drive works fine under dos and
Win95.  Adaptec is set to 334, 11, 6.  At this setting I keep getting
sense errors and it keeps trying to reset.  I've tried other irq and
dma settings to no avail.  When I change the ioport to 130 the install
continued.  When it came to setting up the partition it did not show
/dev/sda on /dev/hda, b, c.

Any help would be appreciated.



1. RedHat install question

When installing linux (via local hard disk) everything was going fine
until it reached the X configuration part... my laptop display was going
nuts and I couldn't get out of autoprobe.  I rebooted and started again
trying to resume from where i left off.  The installation re-installs the
base packages, is there going to be any problems with that?


Segmentation fault (core dumped): cannot find file '.signature'

2. SMP Micronics MB questions

3. Some RedHat Install Questions

4. PSSP 2.3 sysctl reference?

5. Redhat install question

6. New to setting up linux with existing partitions.

7. RedHat install question

8. Trouble with Deny directive

9. Help! Linux RedHat 6.0 install questions

10. SS1/RedHat 4.1 install question

11. Question regarding HD Install, RedHat

12. redhat 7.3 install question

13. Question about RedHat 6.1 install source