by I am probably asking a very common question, but I haven't seen
reference to it anywhere in the docs. Hopefully someone can help me.
I am trying to install the latest Slackware on an IBM Valuepoint
100DX4/Dp. I've actually got the system installed and I'm essentially
trying to shake the bugs out. First, I cannot boot Linux from the
hard disk (a Quantum 540 IDE). Lilo starts to load, prints "LI" up on
the screen and just stops. I had the setup program create a boot
floppy for me to get around this, but it only boots up so far and ends
with a kernel panic.
Does anyone have a clue what I need to do to get around these
problems?
Sean Harp
--
Sean Harp