Very Computer

Hello,

Can anyone tell me how to setup LILO with both IDE and SCSI harddisks.
Linux is installed on my IDE-drive, and I'm running DOS on two
partitions on my SCSI-drive.

When running 'lilo' I get the following message: "Must specify LOADER
for bios 0x81". Apperantly something is missing in my lilo.conf listed
below. (I can install lilo, if i comment the 'other'-section.)

I know it's possible to configure the system like this, since I have had
my system configured like this before, but I lost my linux-partition
(including lilo.conf) when reinstalling Win95.

Thank you!
__________

lilo.conf
   boot=/dev/hda
   map=/boot/map
   install=/boot/boot.b
   prompt
   timeout=100
   image=/vmlinuz
        label=linux
        root=/dev/hda1
        read-only
   other=/dev/sda3
        disk=/dev/sda bios=0x81
        label=dos
        table=/dev/sda3

Equipment:
   Conner CFA540:
       hda1  Linux native
       hda2  Linux swap
   Conner CFP2107A
       sda1  not used (don't know why linux recognizes this partition)
       sda3  dos primary bootable
       sda5  dos extended
Software:
   Redhat, kernel 2.0.8
______

Greetz

Mikael Adolfsson
GlobeCom Network

--------------------------------------------------------------

 Mob: +46-(0)70-625 62 02             http://globecom.net/ma/  
-------- Hiroshima '45,  Tjernobyl '86,  Windows '95 ---------

        http://globecom.net/
        http://globecom.net/ietf/ (for coders)
        http://www.one.se/
        http://gnv.se/
        http://www.underscore.se/sj/

I believe that if you are trying to boot a non-linux OS off anything
other than the first IDE disk you need to specify the boot loader in
your lilo config file (e.g. "loader=/boot/any_d.b").  I think there are
three loaders you can use: /boot/chain.b  /boot/any_b.b   /boot/any_d.b

I think you want to try one of the latter two.   You should read the
README documentation for LILO (it's under /usr/doc somewhere on my
system), or at least read the man page for lilo.conf.