Very Computer

by **Stefan Stommel** » Wed, 29 Nov 2000 16:36:14

My REALTEK 8029 won't initialize. I've configured the card in
linuxconf, but at boot-time linux is unable to configure the IP-address
for eth0. It's a PCI combo card on COAX. When I use my old ISA-ne2k,
all works well (DHCP and all)

The RTL8029 works, cause I use it in windows all the time. Linux
detects it, but can't find the DHCP server. Something to do with
UTP/BNC settings ?

Sent via Deja.com http://www.deja.com/
Before you buy.

by **Konrad Koc** » Sun, 31 Dec 1899 09:00:00

Try this. If you have a 8029 config utility for DOS, please make sure you
have selected Auto Media Type. If you don't have, obtain it from NIC driver
disk. Usually Diag.exe, or something like that. Should works.
Bregs, Konrad.

>My REALTEK 8029 won't initialize. I've configured the card in
>linuxconf, but at boot-time linux is unable to configure the IP-address
>for eth0. It's a PCI combo card on COAX. When I use my old ISA-ne2k,
>all works well (DHCP and all)

>The RTL8029 works, cause I use it in windows all the time. Linux
>detects it, but can't find the DHCP server. Something to do with
>UTP/BNC settings ?

>Sent via Deja.com http://www.deja.com/
>Before you buy.

Very Computer

LAN card doesn't work

LAN card doesn't work

LAN card doesn't work