by I upgraded my computer from a pentium 150 to a Duron 800.
This network card worked sporatically on the P150
However it seems to have a continuous loop of reseting the network and
reporting The following error:
eth0 TX hung, 15vs, 0,
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
eth0 TX hung, 15vs, 0,
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
eth0 Transmit timed out, status e466006, CSR12 00000341, resetting...
I have installed a new EIDE cdrom into the same computer, it seems to
allow me to use modprobe to load the drivers, and when I load said
driver and load the iso9660 fs with modprobe I seem to not be able to
get either to allow me to mount it. It complains I don't have the proper
driver and I don't have the proper FS loaded.
Clue me in on how this should work.. and if I am supposed to pass
parameters to the modules, how the heck do you find out the modules
parameters to be passed with modprobe?
I am currently doing the following.
/sbin/modprobe cdrom
/sbin/modprobe isofs
mount -t iso9660 /dev/hdc