Ok, Ive been following the news postings for several months about
getting an Adaptec 2940W SCSI controller to work under Linux. I
have downloaded the AIC7XXX patch fro remus.nrl.navy.mil and the
Adaptec 2940 patch from Infomagic. After I use rawrite to make
the bootdisk I boot up and my SCSI drives are recognized but I cant
get "fdisk" to partition my drive to continue the installation. I receive
the following error when I give "fdisk" the new partition command "n".
no free sectors available
Infomagic says their patch is only for the Adaptec 2940 not the 2940W.
I would greatly appreciate any help on how I can make this work.
Thanks
Thad Peck