partition blues

partition blues

Post by William Staniewic » Mon, 19 Mar 2001 14:55:53



I just installed Debian Linux on my pc which is sharing space
with Windows95, FreeBSD, and Plan9.

I would like to mount my FreeBSD partition/slice from
linux, but it doesn't seem to want to work entirely.
I can mount root but nothing beyond that. I use the
following to mount it:

        mount -t ufs -o ufstype=44bsd /dev/hda7 /mnt

I presume something is corrupted. What is wrong and can
it be repaired so that I can grab some files off it?
Below is some info... I don't know how to interpret it.

                Bill

Partition check:
 hda: hda1 hda2 hda3! hda4 < hda5 hda6 > < hda7 hda8 hda9 hda10 >

Disk /dev/hda: 128 heads, 63 sectors, 782 cylinders
Units = cylinders of 8064 * 512 bytes

   Device Boot    Start       End    Blocks   Id  System
/dev/hda1   *         1        69    278176+   6  FAT16
/dev/hda2           124       250    512064   39  Unknown
/dev/hda3           251       782   2145024   a5  BSD/386
/dev/hda4            70       123    217728    5  Extended
/dev/hda5            70        85     64480+  82  Linux swap
/dev/hda6            86       123    153184+  83  Linux

BSD disklabel command (m for help): p

8 partitions:
#       start       end      size     fstype   [fsize bsize   cpg]
  a:      251       263*       12*    4.2BSD     1024  8192    16
  b:      263*      281*       17*      swap                    
  c:      251       782       532     unused        0     0      
  e:      281*      286*        5*    4.2BSD     1024  8192    16
  f:      286*      782       496*    4.2BSD     1024  8192    16

 
 
 

partition blues

Post by Eric en Joland » Mon, 19 Mar 2001 16:39:08


Damn you.
DO NOT MULTIPOST. (see col.misc)

Eric

 
 
 

1. Partitioning blues...

I installed Red Hat Linux on my newly bought 20 GB Hard drive and
installation went fine. But then, I wanted to partition 4GB of this
Hard drive for my windows 98 and so used the Linux cfdisk utility to
create a new 4 GB partition with file type 0C (FAT32) and opted to
write the partition table (isn't that what i was supposed to do?).
Now, when I boot in Windows, it DOES show a new partition (D:\ drive)
on the Windows explorer but when i try to access it, it does not allow
me to do that and fails with message:

"D:\is not accessible; A device attached to the system in not
functioning"

Any clues about what is going on here?

TIA.
Ashish.

2. Linux and OS9.x partitions on G4 powerbook

3. partition blues

4. HTTP Refresh Header and Back Button

5. Large HD partition blues...

6. OpenBSD on Apple Macintosh, File System Trouble

7. Partition blues... (SCSI >2GB)

8. Reiserfs

9. partition blues

10. How to convert "Red/Green/Blue" to "Red/Yellow/Blue" color mix

11. cdrom Install hangs- SCO Blue screen blues

12. Partition Software - Partition Magic, Bootit, Boot Manager or Ranish Partition Manager

13. Partitions, Partitions, Partitions