Caldera 1.3 Installation {Help Please} Partitions

Caldera 1.3 Installation {Help Please} Partitions

Post by Shau » Thu, 01 Jul 1999 04:00:00



Here as an exercise, prior to installing Caldera 1.3 ran Fips2.0 to create
2GHZ space for the Linux install.

However, fips2.0 README Word documents para 8. refers as follows "If you
wish to use the partition under Linux, you may now

[1] Change the system indicator byte with Linux FDISK

then

[2] Use MFKS.

As anticipated, having run LISA without implementing [1] and [2] above, Lisa
was unable to locate my newly created partition
/dev/hda2....................

returning

Disk /dev/hda:255.63sectors,788 cyl
Units+cylinders of 16065*512 bytes

Device     Active     Start     Size     ID     System

/dev/hda1     *              1     4281291 C     FAT32(LBA)

/dev/hda2                  534    2048287 C    FAT32(LBA)

when running Verbose System Analysis

Therefore can anyone advise on [1] and [2] above.

Having created the space to install Linux,I cannot get my system to
recognise my newly created partition /dev/hda2  Help please.

Thankyou in anticipation, the time taken out is much appreciated.

Shaun. Uk

 
 
 

1. Caldera 1.3 Installation {Help Please} Partitioning

Here as an exercise, prior to installing Caldera 1.3 ran Fips2.0 to create
2GHZ space for the Linux install.

However, fips2.0 README Word documents para 8. refers as follows "If you
wish to use the partition under Linux, you may now

[1] Change the system indicator byte with Linux FDISK

then

[2] Use MFKS.

As anticipated, having run LISA without implementing [1] and [2] above, Lisa
was unable to locate my newly created partition
/dev/hda2....................

returning

Disk /dev/hda:255.63sectors,788 cyl
Units+cylinders of 16065*512 bytes

Device     Active     Start     Size     ID     System

/dev/hda1     *              1     4281291 C     FAT32(LBA)

/dev/hda2                  534    2048287 C    FAT32(LBA)

when running Verbose System Analysis

Therefore can anyone advise on [1] and [2] above.

Having created the space to install Linux,I cannot get my system to
recognise my newly created partition /dev/hda2  Help please.

Thankyou in anticipation, the time taken out is much appreciated.

Shaun. Uk

2. NAT again...

3. Caldera Open Linux 1.3 Fips ; installation probs help please ;-)

4. Linux on Aptiva S90

5. Red Hat Linux 5.1 - Caldera OpenLinux 1.3 installation: need assistance (London)

6. Solaris Spreadsheet

7. LSing and More'ing after installation of Caldera 1.3

8. PPP and GLIBC

9. Caldera 1.3 vs Caldera 2.3

10. Help w/ install of Caldera 1.3

11. Caldera Open Linux 1.3 Install Crash

12. Trouble installing Caldera 1.3 open linux

13. DHCP client (dhcpcd) for Caldera 1.3?