by I've installed an Equinox SST4 port intelligent serial board in a
RH 6.1 system. It is recognised, and I can use the ports and a
modem connected to it with cu to dial out.
However, when I attempt to do anything like configure linux to be
aware of a modem on it, I don't see these ports.
The device names for inbound use are
ttyQ1a1 ttyQ1a2 ttyQ1a3 ttyQ1a4
The names for outbound use are:
cuq1a1 cuq1a2 cuq1a3 cuq1a4
What do I need to change to make stuff like linuxconf aware of
them?
ZDDDDDDDDDDDDDDDD Modem Configurator DDDDDDDDDDDDDDDDD?
3 Select the port to which your modem is connected. 3
3 If you have no modem, select <Unknown> 3
3 3
3 ZDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDD? 3
3 3( ) /dev/ttyS0 (COM1 under DOS)3 3
3 3( ) /dev/ttyS1 (COM2 under DOS)3 3
3 3( ) /dev/ttyS2 (COM3 under DOS)3 3
3 3( ) /dev/ttyS3 (COM4 under DOS)3 3
3 3(o) Unknown 3 3
3 ZDDDDDD? ZDDDDDD? 3
3 3Accept3 3Cancel3 3
--
------------------------------------------------------------
Neal Rhodes MNOP Ltd (770)-
972-5430
President Lilburn (atlanta) GA 30247 Fax:
978-4741
http://www.mnopltd.com/