by
Hi Samir,
I used Redhat 5 with KDE. When I perform a ppp connection using kppp, i
could connect to my ISP but the system use the IP address I have put on
the Eth0 device 10.1.1.1. So I could not go to Internet because I
couln't use the IP address from the POP
Someone knows the reason of taht problem ?
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:20 errors:0 dropped:0 overruns:0
TX packets:20 errors:0 dropped:0 overruns:0
eth0 Link encap:Ethernet HWaddr 00:A0:C9:28:C1:0B
inet addr:10.1.1.1 Bcast:10.1.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
TX packets:0 errors:0 dropped:0 overruns:0
Interrupt:11 Base address:0xfcc0
ppp0 Link encap:Point-to-Point Protocol
inet addr:10.1.1.1 P-t-P:194.78.248.1 Mask:255.255.255.0
UP POINTOPOINT RUNNING MTU:1500 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0
TX packets:8 errors:0 dropped:0 overruns:0
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
194.78.248.1 0.0.0.0 255.255.255.255 UH 0 0 0
ppp0
10.1.1.0 0.0.0.0 255.255.255.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 1
lo
0.0.0.0 194.78.248.1 0.0.0.0 UG 0 0 0
ppp0
PING 194.78.248.1 (194.78.248.1): 56 data bytes
64 bytes from 194.78.248.1: icmp_seq=0 ttl=255 time=525.8 ms
64 bytes from 194.78.248.1: icmp_seq=1 ttl=255 time=350.8 ms
--- 194.78.248.1 ping statistics ---
3 packets transmitted, 2 packets received, 33% packet loss
round-trip min/avg/max = 350.8/438.3/525.8 ms
nothing
Ir. Charles Moulliard
CM Consulting
|
vcard.vcf < 1K Download |