Board index Linux Setup

Problem with PCI and Adaptec 2940AU

Problem with PCI and Adaptec 2940AU

Post by Martin Torpe L » Thu, 05 Dec 1996 04:00:00



Hi!

I am trying to set up a Linux system on a Z-station ES/P P133 computer with
two SCSI 2GB HD. The SCSI controler is an PCI Adaptec 2940AU BIOS v1.21.

The problem is that the computer does not recognize the adapter card. I get
the following messages when i boot the system:

....
pcibios_int : PCI BIOS revision 2.10 entry at 0xfcf61
Probing PCI hardware.
Warning : Unknown PCI device (9004:6178). Please read include/linux/pci.h
....
SCSI : 0 hosts.
SCSI : detected total.
....

I have tried both Slackware 3.0.0 and 3.1. None are able to find my disks.

Is there a solution to this problem?

        Martin

 
 
 
Top

1. Adaptec 2940AU problems

I recently purchased an Adaptec 2940AU adapter for my system and am
having problems getting Linux to see it. I am using the Adaptec 2940
boot diskette but it does not report my SCSI setup.  I have a quantum
3.2 GB Ultra SCSI-3 drive hooked up to the 2940.  I also have a Mitsumi
12x IDE CD-ROM drive hooked to the M/B. Does the standard 2940 boot disk
support the 2940AU? I didn't see any mention of it. I am using a Pentium
Pro 180 on the Intel Venus M/B. 64MB RAM, and a SoundBlaster 32PnP. Is
this not going to work?

Jared

2. Equinox SST Expansion Bus Failure

3. Future Domain TMC-850M + Texel DM3024 CD???

4. Problem with Adaptec 2940AU

5. Linux DIP Script for Compuserve Internet PPP WANTED

6. Problem with adaptec 2940AU and HP Brio

7. RLL hard drives

8. problems with ADAPTEC 2940AU

9. Adaptec 2940AU problem

10. Adaptec 2940AU/SyJet boot problem

11. Adaptec AHA-2940AU problem

12. Boot problems with Red Hat Linux and Adaptec 2940AU


All times are UTC
Board index