LILO, LILO, LILO

here is my problem----i have 2 physical hard disks --the primary master
has NT
and the primary slave has LINUX(red hat )--i have LILO boot which has 2
images---x(for linux) and nt.

i wanted to upgrade my linux6.0 to 6.1 and so i booted from the cd-rom ---
but it
would give an error saying that "ext2 file system not found" and would
hang.

so---i disconnected my primary master(NT) hdisk and proceeded with the
installation which was successful.

now , at LILO boot when i give X IT SAYS "LOADING X" and stops....it seems-
the LILO is not able to relate the X image to the primary slave.

can you help me to set the LILO properly.....i will be very thankful.

--
Posted via CNET Help.com
http://www.help.com/

2. making tape device

3. lilo can't find /etc/lilo.conf, even though it's there

4. Adding drive to the end of a linear raid array

5. lilo.conf ignored by lilo at boot time

6. WMaker compiliation problems

7. LILO: what does lilo write in boot sector?

8. parallel port ZIP

9. LILO boot LILO