by Ive just installed linux for the first time on a brand spaking new
machine, everything went fine except for the network card installation
the card was in the machine during the installation, and was correctly
configure with all IP address Netmask etc. but now anytime i do a
Ifconfig -a i only get the loop back parameters for "lo" if i do an
ifconfig -a eth0 it says there is no such interface.
could this be because there are no drivers for the NIC?? if this is the
case can someone point me out to where i can obtain them??
thanks!
--== Sent via Deja.com http://www.deja.com/ ==--
---Share what you know. Learn what you don't.---