XServer flickers with 60 Hz , graphic card S3 Visison864

XServer flickers with 60 Hz , graphic card S3 Visison864

Post by Wolfgang Kun » Fri, 26 Feb 1999 04:00:00



Hello,
I try to configure XServer for a S3 Visison864 graphic card. In the
configuration program I select the generic driver for the S3 Vision864.
The XServer run but only with 60 Hz refresh rate.

Could anyone send me an configuration file that allows me to run
XServer with a refresh rate of  72 or 75 Hz ?

Thank you in advance

Wolfgang Kunk

 
 
 

XServer flickers with 60 Hz , graphic card S3 Visison864

Post by Jose L Gomez Dan » Fri, 26 Feb 1999 04:00:00



> Could anyone send me an configuration file that allows me to run
> XServer with a refresh rate of  72 or 75 Hz ?

   What are your /etc/X11/XF86Config Monitor settings? I have my monitor's
refresh rates in there, both for horizontal and vertical.

--
Jose L Gomez Dans                       PhD student
                                        Radar & Communications Group
                                        Department of Electronic Engineering
                                        University of Sheffield UK

 
 
 

XServer flickers with 60 Hz , graphic card S3 Visison864

Post by Wolfgang Kun » Sat, 27 Feb 1999 04:00:00


Hello Jose,
I changed the monitor settings (horizontal and vertical) to the maximum values
the monitor could work with. These settings allows the monitor to work with a
refresh rate up to 75 Hz.

Bye Wolfgang



> > Could anyone send me an configuration file that allows me to run
> > XServer with a refresh rate of  72 or 75 Hz ?

>    What are your /etc/X11/XF86Config Monitor settings? I have my monitor's
> refresh rates in there, both for horizontal and vertical.

> --
> Jose L Gomez Dans                       PhD student
>                                         Radar & Communications Group
>                                         Department of Electronic Engineering
>                                         University of Sheffield UK

 
 
 

1. Problem: X and S3 Vision864 only with 60 Hz

Hello,
I just installed Suse Linux 5.2  and I have a problem with my S3
Vision864 graphic card. I use the S3 Vision864 (generic) driver and I
couldn't reach a higher frequency than 60Hz.
It it possible to configure a higher frequency ?
Could I use another driver for my graphic card and where can I get it ?

Thanks Wolfgang Kunk

2. Linux alternative to NT Load Balancing Service?

3. XFree86, S3 server and HP XP/60 onboard card

4. video card questions

5. savage 4 refresh rate of more then 60 Hz with XFree 3.3.5 ?

6. Starting up an ISP using FreeBSD

7. x11 in RH8 : insists on 60 hz

8. NAT Under OSR505, port forwarding not working.

9. Get ET4000 / >60 Hz running ... Help

10. Going above 60 Hz with Vesa, how ???

11. How to identify Graphics card on Ultra-30/60

12. Radeon 9600 60 Hz HELP

13. swpping graphics cards betweens ultra5's and ultra 60