hello ,
I get two serial pci cards, but I can't configure it for new device.
The Kernel found the card: With "cat /proc/pci" the result was
Bus 0, device 15, function 0:
Network controller: PLX PLX9050 PCI <-> IOBus Bridge (rev 1).
Medium devsel. Fast back-to-back capable. IRQ 11.
Non-prefetchable 32 bit memory at 0xe1002000.
I/O at 0x6400.
I/O at 0x6500.
I/O at 0x6600.
So how can I use setserial to get a new ttyS* - dev. Or must I setup new
device and run setserial afterwards?
Thanks a lot for your help
roger