tone dialing with dip, & rlogin help

tone dialing with dip, & rlogin help

Post by Daniel Sierok » Fri, 31 Jan 1997 04:00:00



  How can I make dip use tone instead instead of pulse dialing?
  Also, can I rlogin to a machine with a different login and password
without typing the other password in every time?
  Thanks,
        Dan

 
 
 

tone dialing with dip, & rlogin help

Post by M. Buchenried » Fri, 31 Jan 1997 04:00:00



>  How can I make dip use tone instead instead of pulse dialing?

[...]

How about simply using

dial T<your number>

Michael

--

*****************************************************************************
Menu, n.:
            A list of dishes which a restaurant has just run out of.

 
 
 

tone dialing with dip, & rlogin help

Post by UNHAPPY_LINUX_USE » Fri, 07 Feb 1997 04:00:00



>    How can I make dip use tone instead instead of pulse dialing?
>    Also, can I rlogin to a machine with a different login and password
>  without typing the other password in every time?
>    Thanks,
>    Dan

Dear friend,
        You can use dip using tone by typing "atdt" after entering terminal mode by typing in "term" under dip .
        Besides , you can rlogin to another machine from your present one !

                                                Regards ,
                                                        UNHAPPY_LINUX_USER

 
 
 

tone dialing with dip, & rlogin help

Post by M. Buchenried » Fri, 07 Feb 1997 04:00:00


UNHAPPY_LINUX_USER writes:

>>    How can I make dip use tone instead instead of pulse dialing?

[...]

Quote:>Dear friend,
>    You can use dip using tone by typing "atdt" after entering
>terminal mode by typing in "term" under dip .

You could as well use a 'dial Txxxxx' command (xxxxx being the phone number).

Michael
--

*****************************************************************************
Menu, n.:
            A list of dishes which a restaurant has just run out of.

 
 
 

1. cannot get dip to do tone dialing

Hi,
        I have a strange problem.  I cannot get dip to do tone-dialing in
the script file.  I have no problem if I use dip interactive, i.e. dip -t
and then do atdt *555555 etc.  I have a HAYES modem and here is my script
file:

port cua3
modem HAYES
reset
send ATQ0V1E1X4\r
dial 5555555

at this point, I would hear that the modem goes off hook and start dialing
in pulse.  I tried to do send atdt then dial 5555 but it didn't like it

Any help is greatly appreciated.

Dennis
------------------------------------------------------------------
                   Georgia Institute of Technology
      School of Electrical Engineering, Atlanta, GA  30332-0250

2. WABI 2.2 and LaserJet 5Si/MX

3. dip dialing pulse instead of tone

4. FTP Shell Script???

5. DIP - Dialing tone....

6. SPARC spontaneous change to firmware state- haven't a clue

7. How to stop modem dialling when no dial-tone present

8. HELP : stdin is not there

9. how to set " modem don't wait for dial tone before dialing "

10. kermit & tone dialing

11. Help:Dip & Dialing In

12. HELP -- bad dial tone