Very Computer

by **Emile van Sebill** » Thu, 31 Dec 1998 04:00:00

I just installed a SIIG I/O Extender 4-port card in a linux box. Each port
has a separate IRQ and I/O address. When I boot win95 from floppy and run
Norton diagnostics with a loop back adapter all 6 ports check out fine.
(2-on-board, 4 new)

Under RH 5.0 5 of the 6 test fine using cat. The failed port is
/dev/cua2 irq 5 port 0x3e8 uart 16550a. Any ideas as to what may be going
on?

Emile

by **d..** » Fri, 01 Jan 1999 04:00:00

Why don't you shut up and fix the problem yourself. Chances are the
computer is as defective as you are. AHEHEHEHEHE !!!

On Wed, 30 Dec 1998 11:03:43 -0800, "Emile van Sebille"

>I just installed a SIIG I/O Extender 4-port card in a linux box. Each port
>has a separate IRQ and I/O address. When I boot win95 from floppy and run
>Norton diagnostics with a loop back adapter all 6 ports check out fine.
>(2-on-board, 4 new)

>Under RH 5.0 5 of the 6 test fine using cat. The failed port is
>/dev/cua2 irq 5 port 0x3e8 uart 16550a. Any ideas as to what may be going
>on?

>Emile

Very Computer

problem getting six rs-232 to run under linux

problem getting six rs-232 to run under linux

problem getting six rs-232 to run under linux