Hi everybody,
Does any of you guys have ever configured XFree86 for a Matrox MGA
Impression Plus (2Mb) ?
Any hint is welcome...
Thanks,
Olivier Werpin
|
owerpin.vcf < 1K Download |
by Olivier Werpi » Mon, 08 Mar 1999 04:00:00
Hi everybody,
Does any of you guys have ever configured XFree86 for a Matrox MGA
Impression Plus (2Mb) ?
Any hint is welcome...
Thanks,
Olivier Werpin
|
owerpin.vcf < 1K Download |
by Barbara A. Severanc » Thu, 11 Mar 1999 04:00:00
> Hi everybody,
> Does any of you guys have ever configured XFree86 for a Matrox MGA
> Impression Plus (2Mb) ?
> Any hint is welcome...
> Thanks,
Barbara
by dmine » Thu, 11 Mar 1999 04:00:00
>> Hi everybody,
>> Does any of you guys have ever configured XFree86 for a Matrox MGA
>> Impression Plus (2Mb) ?
>> Any hint is welcome...
>> Thanks,
>Very bad news I'm afraid... The older Matrox cards are NOT supported. I
>had an Ultima Plus, which uses the same chip set. Metro-X which was
>included with RedHat 5, was supposed to support it, but I could never
>get it to work.
> I finally upgraded to a Matrox Millenium II PCI, and have had great joy
>with XFree ever since. Sorry to say, you will probably need to do the
>same (not necessarily the same upgrade). Check the XFree site for a
>listing of specifically supported cards. I have found it pays to be a
>little "behind" with graphics cards and XFree (This can also be true
>with NT) ;)
>Barbara
1. Matrox MGA Impressions Plus
I have a Matrox MGA Impressions Plus card with 4MB of memory and am
trying to get XFree86 to run. I realize that this is not a supported
card but it would seem that from the HOW-TOs that I have read, it should
work. Has anyone had any luck with this, if so could you provide your
XF86Config entries that you used?
2. case
4. Apache and Microsoft Word Documennts
5. Preset Terminals for TCPIP Addresses
6. matrox impression plus w/ 2Mb VRAM- HELP?
7. write permissions for non root users on automount filesystems
8. Request for Comments Matrox Impression/Compaq QVision1280+p/MGA Impression XFree86
9. Where is the MGA impression plus driver for slackware 3.0 ?
10. How to start SVGA X-Server for MGA Impression Plus ?
11. Matrox MGA Impression + - will it or won't it?