Turtle Beach Santa Cruz sound card problem

Turtle Beach Santa Cruz sound card problem

Post by sbmayer0.. » Tue, 26 Dec 2000 09:45:33



My fresh install of Mandrake 7.2 did not setup my sound properly (i.e. I
can't hear any sounds).

My sound card is a Turtle Beach Santa Cruz card from Voyetra which uses the
Cirrus Logic CS4630 chipset.

The installation identified my sound card as a Cirrus Logic CS4624.

1) Where can I find a driver for this device? (couldn't find it on ZDNET
site).

2) Will I need to rebuild the kernel?

Sent via Deja.com
http://www.deja.com/

 
 
 

1. alsa, modprobe, lib/modules, and a turtle beach santa cruz sound card equals one confusing problem.

- I installed red hat 7.3 with kernel version 2.4.18.  
- I have a turtle beach santa cruz sound card.  
- I could get sound out of the analog/headphone jack by running
sndconfig, the  problem is, I need digital output to use my speakers.
- I ran ./configure, make, make install, snddevices with the alsa
driver 0.9 rc3.
- All of my existing modules were in /lib/modules/2.4.18-3.  More
specifically, the defalt sound modules are in
/lib/modules/2.4.18-3/kernel/drivers/sound.  However, alsa created the
directory /lib/modules/2.4.18 and put its modules in
/lib/modules/2.4.18/misc
- When I do a modprobe or modinfo, it doesn't seem to find any modules
located in the /lib/modules/2.4.18.  I tried copying all of the alsa
modules from their new directory into the default directory, and when
I run a modprobe I get a lot of unresolved symbol errors, probably 30
or so.
- Also, I ran alsaconf and it created a new modules.conf for me, but
in the line "alias snd-card-0 snd-card-cs461x" it refers to a module
snd-card-cs461x which does not exist.  The closest thing to it is
snd-cx46xx.  I tried renaming it but I get the same unresolved symbol
errors.

so:
1) Why does alsa create its modules in /lib/modules/2.4.18 instead of
/lib/modules/2.4.18-3?  Did I do the right thing in copying them to
the default location?
2) What's the deal with snd-card-461x vs. snd-46xx
3) What is the cause of the "unresolved symbol" errors?
4) Is there anything else that I am missing?

I would really appreciate any help anyone can give me.

2. LILO removed after reinstalling Win98

3. bad sound with Turtle Beach Santa Cruz (cs46xx)

4. Troubleshooting System Freeze

5. Rear Speakers on Turtle Beach Santa Cruz card

6. ppp Dialer: How to setup?

7. Voyetra Turtle Beach Santa Cruz driver

8. DNS

9. Turtle Beach Santa Cruz in FreeBSD?

10. Turtle Beach drivers? (Santa Cruz)

11. Turtle Beach Santa Cruz

12. Turtle Beach Santa Cruz in Debian?

13. Turtle Beach Santa Cruz