Board index Linux Setup

1.2.8: boot error: hda: DRDY error: status=0x01 { Error }

1.2.8: boot error: hda: DRDY error: status=0x01 { Error }

Post by Sam Steingo » Fri, 09 Jun 1995 04:00:00



Short: df in linux 1.2.8 reports a smaller partition than Norton utilities!
        THIS HAS NOTHING TO DO WITH THE ROOT SPACE!!!
Long:
The followin is a report by Norton SysInfo:

     *   Partition Tables   *
                    Starting           Ending         Relative  Number of
   System Boot Side Track Sector  Side Track Sector   Sectors   Sectors
   BIGDOS Yes   1       0    1    11     250   34          34    102,374
     ?    No    0     251    1    11   1,003   34     102,408    307,224
     ?    No    0   1,004    1    11   1,023   34     409,632      8,160

One would expect a 50MB dos, 150MB ext2 and 4 mb swap (fstab):
/dev/hda2       /               ext2    defaults        1       1
/dev/hda1       /dosc           msdos   defaults        1       1
/dev/hda3       none            swap    sw

ok?! NO!!! df says:
Filesystem         1024-blocks  Used Available Capacity Mounted on
/dev/hda2             134326   85303    41343     67%   /
/dev/hda1              50964   46168     4796     91%   /dosc

so: where are my 16MB from /dev/hda2?!!!
note that 85+41=126, so the difference with 134 is 8 which is roughly 5%
for the root, so 150-134=16 is unaccounted for.

The following is probably related to the problem. When I boot the
system, I get the following error messages regarding the HD (sorry for
the lengthy report; you can search for "error"):

Jun  4 08:22:10 overland syslogd: restart
Jun  4 08:22:11 overland kernel: Kernel logging (proc) started.
Jun  4 08:22:11 overland kernel: Console: colour EGA+ 80x25, 1 virtual console (max 63)
Jun  4 08:22:11 overland kernel: Calibrating delay loop.. ok - 16.77 BogoMips
Jun  4 08:22:11 overland kernel: Serial driver version 4.11 with no serial options enabled
Jun  4 08:22:11 overland kernel: tty00 at 0x03f8 (irq = 4) is a 16550A
Jun  4 08:22:11 overland kernel: tty01 at 0x02f8 (irq = 3) is a 16450
Jun  4 08:22:11 overland kernel: lp1 at 0x0378, using polling driver
Jun  4 08:22:11 overland kernel: PS/2 auxiliary pointing device detected -- driver installed.
Jun  4 08:22:11 overland kernel: ftape: allocated 3 buffers aligned at: 00210000
Jun  4 08:22:11 overland kernel: hda: ST3243A, 204MB w/32KB Cache, CHS=1024/12/34, MaxMult=32
Jun  4 08:22:11 overland kernel: ide0: primary interface on irq 14
Jun  4 08:22:11 overland kernel: Floppy drive(s): fd0 is 1.44M
Jun  4 08:22:11 overland kernel: FDC 0 is a 8272A
Jun  4 08:22:11 overland kernel: Memory: 19028k/20608k available (820k kernel code, 384k reserved, 376k data)
Jun  4 08:22:11 overland kernel: This processor honours the WP bit even when in supervisor mode. Good.
Jun  4 08:22:11 overland kernel: Swansea University Computer Society NET3.019
Jun  4 08:22:11 overland kernel: Swansea University Computer Society TCP/IP for NET3.019
Jun  4 08:22:11 overland kernel: IP Protocols: ICMP, UDP, TCP
Jun  4 08:22:11 overland kernel: PPP: version 0.2.7 (4 channels) NEW_TTY_DRIVERS OPTIMIZE_FLAGS
Jun  4 08:22:11 overland kernel: TCP compression code copyright 1989 Regents of the University of California
Jun  4 08:22:11 overland kernel: PPP line discipline registered.
Jun  4 08:22:11 overland kernel: SLIP: version 0.8.3-NET3.019-NEWTTY (4 channels) (6 bit encapsulation enabled)
Jun  4 08:22:11 overland kernel: CSLIP: code copyright 1989 Regents of the University of California
Jun  4 08:22:11 overland kernel: eth0: ewrk3_probe(): Detected a device already registered at 0x2e0
Jun  4 08:22:11 overland kernel: eth0: ewrk3_probe(): Detected a device already registered at 0x360
Jun  4 08:22:11 overland kernel: eth0: ewrk3_probe(): Detected a device already registered at 0x3c0
Jun  4 08:22:11 overland kernel: eth0: D-Link DE-600 pocket adapter: not at I/O 0x378.
Jun  4 08:22:11 overland kernel: D-Link DE-620 pocket adapter not identified in the printer port
Jun  4 08:22:11 overland kernel: Checking 'hlt' instruction... Ok.

Jun  4 08:22:11 overland kernel: Partition check:
Jun  4 08:22:11 overland kernel: hda: DRDY error: status=0x01 { Error }
Jun  4 08:22:11 overland kernel: hda: DRDY error: error=0x04 { DriveStatusError }
Jun  4 08:22:11 overland kernel: hda: DRDY error: status=0x01 { Error }
Jun  4 08:22:11 overland kernel: hda: DRDY error: error=0x04 { DriveStatusError }
Jun  4 08:22:11 overland kernel: hda: DRDY error: status=0x01 { Error }
Jun  4 08:22:11 overland kernel: hda: DRDY error: error=0x04 { DriveStatusError }
Jun  4 08:22:11 overland kernel: hda: DRDY error: status=0x01 { Error }
Jun  4 08:22:11 overland kernel: hda: DRDY error: error=0x04 { DriveStatusError }
Jun  4 08:22:11 overland kernel: ide0: do_ide_reset: success
Jun  4 08:22:11 overland kernel:   hda: hda1 hda2 hda3
Jun  4 08:22:11 overland kernel: VFS: Mounted root (ext2 filesystem) readonly.
Jun  4 08:22:11 overland kernel: Adding Swap: 4076k swap-space
Jun  4 08:22:16 overland kernel: Unable to identify CD-ROM format.

PLEASE HELP!!!!

--
<A HREF="http://www.math.ucla.edu/~shteingd">    Sam Steingold    </A>
I would appreciate comments on / corrections of my English from native
English speakers. Thank You!

 
 
 
Top

1. /dev/hdc status error: status=0x01 {Error}

I am getting this error when booting linux...Below is a clip from the
syslog.

Now, originally, I had NO ST3243A HDD attached to the system. My CD-ROM
was attached and being used as /dev/hdc. But I found this 200 meg drive
and attached it to the secondary master. Then this error came up! The
cd-rom and 200 meg drive work just fine...What the hell is up?

    Any help would be greatly appreciated. Please respond via email, as

Thanks!
Chris

----- snip ----- snip ------ snip -----
FSTAB
/dev/hda2       swap    swap    defaults        1   1
/dev/hda3       /       ext2    defaults        1   1
/dev/hdc1       /cgu    ext2    defaults        1   1
/dev/hdb        /cdrom  iso9660 ro,noauto       1   1
none            /proc   proc    defaults        1   1

----- snip ----- snip ------ snip -----
SYSLOG

Oct 28 18:20:45 beavis kernel: hda: FUJITSU M1638TAU, 2452MB w/128kB
Cache, LBA, CHS=622/128/63
Oct 28 18:20:45 beavis kernel: hdb: 12X, ATAPI CDROM drive
Oct 28 18:20:45 beavis kernel: hdc: ST3243A, 204MB w/32kB Cache,
CHS=1024/12/34
Oct 28 18:20:45 beavis kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Oct 28 18:20:45 beavis kernel: ide1 at 0x170-0x177,0x376 on irq 15
Oct 28 18:20:45 beavis kernel: Started kswapd v 1.4.2.2
Oct 28 18:20:45 beavis kernel: Partition check:
Oct 28 18:20:45 beavis kernel:  hda: hda1 hda2 hda3
Oct 28 18:20:45 beavis kernel:  hdc:hdc: status error: status=0x01 {
Error }
Oct 28 18:20:45 beavis kernel: hdc: status error: error=0x04 {
DriveStatusError }
Oct 28 18:20:45 beavis kernel: hdc: drive not ready for command
Oct 28 18:20:45 beavis kernel: hdc: status error: status=0x01 { Error }
Oct 28 18:20:45 beavis kernel: hdc: status error: error=0x04 {
DriveStatusError }
Oct 28 18:20:45 beavis kernel: hdc: drive not ready for command
Oct 28 18:20:45 beavis kernel: hdc: status error: status=0x01 { Error }
Oct 28 18:20:45 beavis kernel: hdc: status error: error=0x04 {
DriveStatusError }
Oct 28 18:20:45 beavis kernel: hdc: drive not ready for command
Oct 28 18:20:45 beavis kernel: hdc: status error: status=0x01 { Error }
Oct 28 18:20:45 beavis kernel: hdc: status error: error=0x04 {
DriveStatusError }
Oct 28 18:20:45 beavis kernel: hdc: drive not ready for command
Oct 28 18:20:45 beavis kernel: ide1: reset: success
Oct 28 18:20:45 beavis kernel:  hdc1
Oct 28 18:20:45 beavis kernel: VFS: Mounted root (ext2 filesystem)
readonly.
Oct 28 18:20:45 beavis kernel: Adding Swap: 12092k swap-space (priority
2144)

2. Job Opportunities

3. hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC )

4. seting up linux as dail in localonly tcp/novel/NT network

5. hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC }

6. java/43859: Update port: Jakarta Ant 1.5.1

7. Slack96 boot: "block move error 0x01", CRC error

8. Newbie help

9. disk error: kernel: hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }

10. How can fix this error (hda error io error )

11. Bloody hda: timeout & DRDY error!!

12. hdb: DRDY error: status=0x00 { }

13. HELP: Can't boot linux (DRDY error)


All times are UTC
Board index