Very Computer

by **J La** » Sat, 08 Jun 2002 12:28:26

I own a Canon BJC-210, and there's something jammed down into the paper
feed area, blocking its path. If I could only pop open the printer
somehow and remove the offending piece of crud (a chunk of poster
stick-tack, I believe), all would be well.

However, the printer is one of those snap-together plastic jobs, with
nary a*to be found. Aside from me taking a hacksaw to the thing,
is there an easy way to pop off a panel so I can get inside the thing?

Thanks,

Jason

by **Chia Ah Tee, Josep** » Sat, 08 Jun 2002 15:08:33

Put a piece of half 4A size paper or thin cardboard into the feed tray and run print.
Let the printer roller turns a number of times and hope that stauff will dislodge and roll out.
You could write to Canon for assistance.

Joseph Chia A.T

-----Original Message-----

Posted At: Friday, June 07, 2002 11:41 AM
Posted To: printers
Conversation: Opening a Canon BJC-210
Subject: Opening a Canon BJC-210

I own a Canon BJC-210, and there's something jammed down into the paper
feed area, blocking its path. If I could only pop open the printer
somehow and remove the offending piece of crud (a chunk of poster
stick-tack, I believe), all would be well.

However, the printer is one of those snap-together plastic jobs, with
nary a*to be found. Aside from me taking a hacksaw to the thing,
is there an easy way to pop off a panel so I can get inside the thing?

Thanks,

Jason

by **Steve Wilk** » Wed, 12 Jun 2002 06:04:52

Quote:> I own a Canon BJC-210, and there's something jammed down into the paper
> feed area, blocking its path. If I could only pop open the printer
> somehow and remove the offending piece of crud (a chunk of poster
> stick-tack, I believe), all would be well.

> However, the printer is one of those snap-together plastic jobs, with
> nary a*to be found. Aside from me taking a hacksaw to the thing,
> is there an easy way to pop off a panel so I can get inside the thing?

> Thanks,

> Jason

Jason

Turn the printer upside down. There are 2 slots on either side insert a
small flat*driver and move outwards this will unclip the sides. unclip
the back by inserting the screwdriver under the edge of the rear towards the
corner the case should then lift off.

Steve