1600 with 11.3(1) reboots on dialout attempt !!

1600 with 11.3(1) reboots on dialout attempt !!

Post by Ekkehard Strei » Sat, 31 Jan 1998 04:00:00



Hello, newsgroup!

I have a problem with a 1603 and a newly installed 11.3(1) IOS (ip
only): As long as i configure dial-on-demand directly to BRI0,
everything is fine (I use NAT and ip address negotiated). Changing to
dialer rotary configuration is also o.K. But when I try switching to
dialer profile configuration, the machine boots when I try to ping
over ISDN:

ping 192.31.7.130  ! www.cisco.com

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.31.7.130, timeout is 2 seconds:
.
*** BUS ERROR ***
access address = 0xffffffff
program counter = 0x810e72a
status register = 0x2700
vbr at time of exception = 0x4000000
special status word = 0x0045
faulted cycle was a longword read

Is this a known problem with IOS 11.3(1)? Or is there a principial
conflict when using dialer pools together with ip add negotiated ?

Please, help !!

--
Ekkehard Streit