Newbie question :: Multilink PPP and 804 -

Newbie question :: Multilink PPP and 804 -

Post by neal o » Sun, 19 Dec 1999 04:00:00



Try:

router#show ppp multilink

Dialer1, bundle name is 0300.0000.0000
  0 lost fragments, 95 reordered, 0 unassigned, sequence 0x160/0xF5
rcvd/sent
  0 discarded, 0 lost received, 1/255 load
  Member links: 2 (max not set, min not set)
    BRI0:1
    BRI0:2
router#    

Here you can see both channels are members of the multilink

Neal


> After playing with an 804 for a few days I've managed to make it connect
> to an Ascend MAX 4004.  Now, I'm not sure if I've gotten the Multilink
> or bonding right.

> This is the output from 'show isdn active'

> border>show isdn a
> -------------------------------------------------------------
>                                 ISDN ACTIVE CALLS
> -------------------------------------------------------------
> History table has a maximum of 100 entries.
> History table data is retained for a maximum of 15 Minutes.
> -------------------------------------------------------------
> Call    Calling      Called       Remote  Seconds Seconds Sec
> Type    Number       Number       Name    Used    Left    Idl
> -------------------------------------------------------------
> Out                 3240519  +.7b53.ecfb     1557
> Out                 3240519  +.7b53.ecfb       24
> -------------------------------------------------------------

> border>

> I realize that I've got 2 channels up and running, but does that
> necessarily mean that they are actually bonded?  I ask because it
> doesn't seem as if I'm getting anything close to 128K.  Just for kicks,
> I've included some of the relevant information from the config.  I think
> I should mention that the router is doing NAT for a small home network,
> that seems to be working fine.

> border#show run
> Building configuration...

> Current configuration:
> !
> version 12.0
> service timestamps debug uptime

> < -- snip -- >

> interface BRI0
>  description ** isdn to internet **
>  no ip address
>  no ip directed-broadcast
>  ip nat outside
>  encapsulation ppp
>  no ip mroute-cache
>  dialer rotary-group 1
>  isdn switch-type basic-dms100
>  isdn spid1 XXXXXXXXXXXXXX XXXXXXX
>  isdn spid2 XXXXXXXXXXXXXX XXXXXXX
>  isdn voice-priority XXXXXXX in always
>  isdn voice-priority XXXXXXX out always
>  isdn voice-priority XXXXXXX in always
>  isdn voice-priority XXXXXXX out always
>  isdn incoming-voice modem
> !
> interface Dialer1
>  ip address negotiated
>  no ip directed-broadcast
>  ip nat outside
>  encapsulation ppp
>  no ip split-horizon
>  dialer in-band
>  dialer string XXXXXXX class DialClass
>  dialer load-threshold 10 outbound
>  dialer-group 1
>  ppp authentication pap callin
>  ppp pap sent-username XXXXXXX password 7 -sorry not today -
>  ppp multilink bap
>  ppp bap call accept
>  ppp bap call request
>  ppp bap call timer 5
>  ppp bap drop timer 60
>  ppp bap timeout pending 20
>  ppp bap max dial-attempts 3
> !
> !
> interface Dialer2
>  no ip address
>  no ip directed-broadcast
>  no logging event link-status
>  no cdp enable

> Thanks,
> Jim

--
To email me, remove nospam. from the beginning of my address.