Quote:>On Falcon I've got the very last STING version. On PC, I have
>windozz 95B. I've got the adequate parallel cable (intensively
>tested with Parallel Copy).
Are there any Windows drivers for plip? I got the impression you would
need Linux on the pc side?
First try to get a tcp/ip link between pc-Falcon without any
masqerading. When this works it's easy to setup the masqerade part.
When I tried to link Linux/Mint to STinG with ppp there were lots of
problems. This was last June so things may have gone for the better. If
possible try with SLIP first.
I do have a very reliable ppp link between my Win-95 pc and the TT
here via seral cable. I have to start "Remote access" on the pc side
first and then activate the port in STinG. The opposite does not work.
>Here is my ROUTE.TAB file :
># cnx parallel port
>18.104.22.168 255.255.255.0 Centr. PLIP 0.0.0.0
>0.0.0.0 0.0.0.0 Masquerade 0.0.0.0
># cnx modem 2
>0.0.0.0 0.0.0.0 Modem 2 0.0.0.0
>Is there an error some where ?
First you need ip-addresses for your ports. I would use:
Falcon: 192.168.1.1 . Set this in "STinG port setup" cpx for the plip
port. Don't forget to set protocol (ppp/slip) and mtu at the same time.
This port has to be manually activated.
Pc: 192.168.1.2 to be set on the pc itself.
If you activate "Add default route through port" in the STinG dialer
configuration pages yuo don't need any default route in ROUTE.TAB . My
ROUTE.TAB would look like this (with real TAB:s instead of spaces):
192.168.1.0 255.255.255.0 Centr. PLIP 0.0.0.0
That's all to get the local connection. When this works try to add
Quote:>Moreover, in the CPX for configuring the ports, I've set the
>"masquerading" like this :
>- virtual machine : 22.214.171.124
>- masking IP (modem 2) : 126.96.36.199
It's best to simply keep the preset addresses as these will work just
fine. Note, you should _not_ activate the masquerade pseudo port. It
will be activated by the Dialer when you get online. Modem 2 should not
be activated either. Also you must select "Use masquerading" in the
Dialer setup pages.
You must set the nameserver numerical address on the pc by hand.
Please note that the only file you must edit by hand is ROUTE.TAB . In
DEFAULT.CFG you may also want to raise ALLOCMEM to 150000 or so.
Everything else is entered in the program dialoges.
<<Produced with 100% pure Atari equipment>>